Autor Beitrag
Cruiser23
ontopic starontopic starontopic starontopic starontopic starontopic starontopic starhalf ontopic star
Beiträge: 191

WinXP
D7 Prof.
BeitragVerfasst: Sa 29.05.04 14:01 
Hi,

wie kann ich ein Bild Pixel für Pixel untersuchen, und dabei nach Mustern suchen?

_________________
Du steckst immer in der Sch****, das einzige, was sich ändert, ist die Tiefe!
MartinPb
ontopic starontopic starontopic starontopic starontopic starontopic starhalf ontopic starofftopic star
Beiträge: 698



BeitragVerfasst: Sa 29.05.04 14:06 
Was ist jetzt die Frage? Wie man auf Pixel zugreift oder mach Mustern sucht?

_________________
Gruß
Martin
Cruiser23 Threadstarter
ontopic starontopic starontopic starontopic starontopic starontopic starontopic starhalf ontopic star
Beiträge: 191

WinXP
D7 Prof.
BeitragVerfasst: Sa 29.05.04 14:09 
Leider beides... :oops:

_________________
Du steckst immer in der Sch****, das einzige, was sich ändert, ist die Tiefe!
MartinPb
ontopic starontopic starontopic starontopic starontopic starontopic starhalf ontopic starofftopic star
Beiträge: 698



BeitragVerfasst: Sa 29.05.04 14:16 
Dann mach zwei Threads draus. Sonnst kriegst du keine Frage richtig beantwortet.

Zu der ersten Frage kannst du dir ScanLine angucken.

_________________
Gruß
Martin
Cruiser23 Threadstarter
ontopic starontopic starontopic starontopic starontopic starontopic starontopic starhalf ontopic star
Beiträge: 191

WinXP
D7 Prof.
BeitragVerfasst: Sa 29.05.04 14:26 
OK, mach ich! Danke!

_________________
Du steckst immer in der Sch****, das einzige, was sich ändert, ist die Tiefe!
Christian S.
ontopic starontopic starontopic starontopic starontopic starontopic starhalf ontopic starofftopic star
Beiträge: 20451
Erhaltene Danke: 2264

Win 10
C# (VS 2019)
BeitragVerfasst: Sa 29.05.04 14:53 
Da Du ja jetzt zwei neue Threads eröffnet hast, mache ich hier mal zu. :-)

*closed*

_________________
Zwei Worte werden Dir im Leben viele Türen öffnen - "ziehen" und "drücken".
Dieses Thema ist gesperrt, Du kannst keine Beiträge editieren oder beantworten.

Das Thema wurde von einem Team-Mitglied geschlossen. Wenn du mit der Schließung des Themas nicht einverstanden bist, kontaktiere bitte das Team.