Autor Beitrag
Patschi
Hält's aus hier
Beiträge: 15



BeitragVerfasst: Fr 11.07.03 17:44 
Wie kann ich die Seitenränder meines Druckers verändern. Wenn ich etwas ausdrucke, dann wird ab ca. 1 cm vor dem unteren Rand nichts mehr gedruckt. Bei den anderen Rändern wird aber bis fast angrenzend gedruckt
derDoc
ontopic starontopic starontopic starontopic starontopic starontopic starontopic starhalf ontopic star
Beiträge: 623

Win Vista Prof
D2007 Prof
BeitragVerfasst: Fr 11.07.03 17:49 
Die Jungs vom SwissDelphiCenter haben dafür eine Lösung.

_________________
MfG derDoc
There are only 10 types of people: those who understand binary and those who don't.
AndyB
ontopic starontopic starontopic starontopic starontopic starontopic starontopic starhalf ontopic star
Beiträge: 1173
Erhaltene Danke: 14


RAD Studio XE2
BeitragVerfasst: Fr 11.07.03 18:15 
@derDoc: Damit ermittelt er nur die Ränder, kann sie aber nicht verändern.

Patschi hat folgendes geschrieben:
Wie kann ich die Seitenränder meines Druckers verändern.

[naiv]Druckerdeckel öffnen, Druckkopf herausreisen und etwas versetzt wieder einbauen.[/naiv]


Zitat:
Wenn ich etwas ausdrucke, dann wird ab ca. 1 cm vor dem unteren Rand nichts mehr gedruckt. Bei den anderen Rändern wird aber bis fast angrenzend gedruckt

Dann hast du noch nicht andere Drucker ausprobiert. Der eine druckt bis zum Seitenende, beginnt dafür erst 1.5 cm vom oberen Rand usw.

Warum denkst du heißt das "bedruckbare Fläche" ? Das ist physikalisch vom Drucker her festgelegt. Und das lässt sich nicht per Software verändern.

_________________
Ist Zeit wirklich Geld?
derDoc
ontopic starontopic starontopic starontopic starontopic starontopic starontopic starhalf ontopic star
Beiträge: 623

Win Vista Prof
D2007 Prof
BeitragVerfasst: Fr 11.07.03 18:52 
@AndyB: Du hast recht, da habe ich mich verlesen.

Ich habe mal geschaut und kann dir auch nur sagen, dass dieser Rand je nach Drucker größer oder etwas kleiner ist. Dies ist eine Hardware Sache, da kannst du mit Software nichts dran verändern.

_________________
MfG derDoc
There are only 10 types of people: those who understand binary and those who don't.